Engine Reassembly
- 82 -
3.3.4. Oil spray nozzle
z
Assemble the oil spray nozzle.
z
Tighten the fixing bolts.
3.3.5. Tappet
z
Coat the tappet wholly with clean oil and
push in the tappet hole of the cylinder
block.
3.3.6. Crankshaft
z
Put the wear ring into the heater to heat
it up to 150 ~ 200
°
C level, push it over
the crankshaft by means of a jig.
z
Assemble the main bearing to the
cylinder block and coat it with engine oil.
Then assemble the bearing that has a
hole to the cylinder block side and one
that has no hole to the bearing cap and
be careful not to change.
EFM2059I
EAMD072S
EA6M2009
Wear ring
EFM2060I
To Next Page
Loading...
Need help?
General
