196 Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
Alarms
The relevant alarm limit (2) is preselected.
2. Adjust the value (2) and confirm.
The device can be configured so that the Quick setup dialog opens automatically in
the event of an alarm, see page 208.
10.4 Adopting alarm settings when changing the ventilation
mode
When the ventilation mode is changed, the alarm settings are also adapted.
Depending on the mode, alarm settings can either be adopted or set to Off.
For some modes, it can be configured whether or not the settings are adopted.
Observe the information in the following section: "Vertical tab "Config. 2"", page 209
However, the settings can be adjusted during operation at any time.
36016
To Next Page
Loading...
Need help?
General
