Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n 271
Disposal
The replacement of the integrated patient-gas measurement module is described in
the chapter "Replacing the patient-gas measurement module (PGM)" (see
"Replacing the patient-gas measurement module (PGM)", page 238).
14 Disposal
14.1 Safety instructions
Risk of infection
If the product has not been reprocessed properly, it may be contaminated with
pathogens. As a result, persons could be put at risk.
Perform the following measure before servicing, before returning the device, and
before disposal:
► Perform the reprocessing in accordance with the reprocessing instructions
supplied with the product.
Risk of environmental pollution
If electrical and electronic equipment is not disposed of professionally, this may
cause damage to the environment.
► Dispose of this device in accordance with the national regulations (see
"Disposing of the device", page 271).
14.2 Disposing of the device
The disposal of electrical and electronic devices is subject to special guidelines.
This device must be disposed of in accordance with national regulations. In
countries of the European Union, Dräger will organize the return of the device.
Additional information is available at www.draeger.com (search term: WEEE).
14.3 Disposing of accessories
When disposing of the following accessories, follow the infection prevention policy
of the health-care facility and the respective instructions for use:
– Flow sensors
– Breathing hoses
– Filter, HME, HMEF
– Breathing bag
– Masks
– Water trap
– CLIC absorber, Infinity ID CLIC absorber
– Soda lime
Due to potential contamination, dispose of other disposable products with patient
gas contact in accordance with the infection prevention policy of the health-care
facility.
Observe the reprocessing instructions supplied with the device.
To Next Page
Loading...
Need help?
General
