Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n 223
Configuration
11.6 Transferring device configurations
The configuration of a device can be exported to a USB mass storage device and
then imported on another device.
The configuration can only be transferred completely if the hardware and software
characteristics are identical on both devices. If these characteristics (e.g., gas
mixer, gas measurement) are different or if configuration data are missing, certain
settings will be reset to the factory defaults or switched off.
To achieve as complete a transfer as possible, use a device with the greatest
possible range of features as the starting point for exporting to a device with fewer
features.
Prerequisites:
– The USB port is activated in the system setup.
– A USB mass storage device is connected to the USB port.
● Open the System setup > Im/Export config. > Im/Export config. page (1).
The configurations saved on the USB mass storage device are displayed in a
list (4). If not all of the configurations are displayed, delete all configurations from
the USB mass storage device that are not needed or move them to a subdirectory
on the USB mass storage device.
The following settings are neither imported nor exported:
– Device name
– Date and time
– IP address
– Passwords
36030
4
1
3
2
1
To Next Page
Loading...
Need help?
General
