Ecolab EcoAdd User Manual

Perform calibration
Fig. 90: Software setting: ‘Calibration’
[Calibration] - start:
1.
[Main menu] Press the button.
ð
The [Main menu] is displayed.
2. [Calibration] - select.
ð
The screen for starting [Calibration]
is displayed.
3. [Start] - press.
ð
Screen changes to the ‘calibration step 1’.
Calibration step 1 runs automatically
.
The screen page for ‘calibration step 1’ is called up.
4. Enter the quantity in litres (before the decimal point) using the scrollbar
.
5. Select the quantity in millilitres after the decimal point.
6. Enter the quantity in millilitres (after the decimal point) using the scrollbar
.
7.
[Press the Next button] .
ð
Screen changes to the ‘calibration step 2’.
The ‘calibration step 2’ runs automatically
.
The screen page for calibration step 2 is called up.
8. Enter the quantity in litres (before the decimal point) using the scrollbar
.
9. Select the quantity in millilitres after the decimal point.
10. Enter the quantity in millilitres (after the decimal point) using the scrollbar
.
11.
[Press the Next button] .
ð
The setting is saved, and the screen switches back to [Operating display] .
Commissioning
134Rev. 2-05.2018

Ecolab EcoAdd Specifications

General

Brand	Ecolab
Model	EcoAdd
Category	Water Pump
Language	English