9.6 Confirm the pump service
Provided that an access code has been set in the pump, the pump servicing
can only be done with the access authorisation
‘Administrator’ !
Symbol Description of service displays
Service info with blue background: No servicing required
Service info with orange background: Advance notice of a servicing
Service info with a red background: Servicing overdue
Fig. 96: Confirm the pump service
1. In order to confirm a service, click the‘Service’ shown on the screen.
In order to access the setting, press the ‘Service’ symbol and hold it in for
approximately 3 seconds.
2. This step can be skipped if there is no password query here.
If the [access code] is enabled , please note the following:
Ä
Chapter 7.6 ‘Main menu’ on page 66.
ð
The screen switches to the query for: ‘Pump service’.
3.
By pressing the Cancel button , the information screen that is displayed is closed
again.
ð
The service has not been reset, and the operation screen is displayed.
4.
By pressing the OK button , the information screen that is displayed is closed
again, and the operation screen is displayed.
5. The operation screen now shows the new servicing time suitable to the material
pairing of the pump under (
Ä
Chapter 7.9.11 ‘Service interval’ on page 102).
Operation
143 Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
