6 Assembly, installation, modification and upgrades
Personnel:
n
Manufacturer
n
Mechanic
n
Service personnel
n
Specialist
6.1 General information and safety
NOTICE!
General instructions for installation and assembly:
–
The pump must be installed at an easily accessible, frost-protected
location.
– The ambient conditions indicated in the "Technical Data" must be complied
with.
– The pump must be installed in a horizontal position.
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools during assembly
,
maintenance or troubleshooting.
Only use the correct tools.
DANGER!
Damage and injuries may occur if installation, maintenance or repair
work is carried out incorrectly
.
– All installation, maintenance and repair work may only be performed by
authorised and trained experts in accordance with valid local regulations.
– The safety regulations and the required protective clothing when working
with chemicals must be complied with. Attention must be paid to the
information included on the product data sheet for the metering medium
used.
– The metering medium supply must be isolated and the system cleaned
prior to installation, maintenance and repair work.
DANGER!
Electrical dangers
Electrical hazards are marked by the symbol opposite. W
ork in these areas
may only be carried out by trained personnel with the appropriate
authorisation.
DANGER!
Personal protective equipment, hereinafter referred to as PPE, is used to
protect personnel. The personnel who set up and install the pump must use
suitable PPE to protect against injury
.
Assembly, installation, modification and upgrades
38Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
