9.8.1.2.2 [Operating Mode] [Pulse] - Quantity
Fig. 103: Operating Mode: Pulse
1.
[Call up Main menu] :
Ä
Chapter 7.6 ‘Main menu’ on page 66
2. [Select Operating Mode] - [Pulse] .
3.
[Press the Next] button.
ð
Screen change for setting: ‘Pulse interval’.
4. Do NOT enter ANY pulse interval, or set the pulse interval to 0!
For this, set 0 in the place before the decimal point using the scrollbar
.
Then select the field for entering the place after decimal point and set it likewise to 0
using the scrollbar.
5.
[ Press the Next] button.
ð
Screen changes to the ‘Pulse memory’ query
.
6. Select whether the ‘pulse memory’
is to be used.
ð
If the ‘Pulse memory’ has been selected, a
is set in the selection box.
7.
Press the button.
ð
Settings are saved, and the screen returns to the [Operating Mode] .
8.
Press the button.
ð
The screen switches back to the overview [main menu] .
9.
Press the button.
ð
The screen switches back to the [operating display] .
10. Press the displayed value (l/pulse) for the rate for approx. 3 seconds.
ð
The configuration page for changing the unit (l/pulse) is displayed
11. Slightly tap the desired unit (l/pulse, ml/pulse, G/pulse) of the concentration setting
and select it.
12.
Press the button.
ð
The screen switches back to the concentration setting.
13. If necessary
, adjust the concentration value once again with the newly set unit.
14.
Press the button.
ð
The screen switches back to the [operating display] .
Operation
152Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
