Ecolab EcoAdd User Manual

6.2.2 Wall mounting
Fig. 10: Preparations for wall mounting
1. T
urn mounting plate over.
2.
For wall mounting, fastening elements with the code 2 (Fig. 10, pos. 3)
and with code 1 (Fig. 10, pos. 2)
are used.
Insert fastening elements (labelled: 1, Fig. 10, pos. 2) from behind into the two upper
openings marked "wall"
(= wall mounting)and engage into position.
3. Insert fastening elements (labelled: 2, Fig. 10, pos. 3 ) from behind into the two lower
openings marked "wall" and engage into position.
4. T
urn mounting plate over again and hold it against the required mounting position.
5. Using mounting plate as a template, mark required boreholes with a sharp pencil.
6. Make the holes.
7. Fasten the mounting plate securely to the wall.
The hooks of the fastening elements must point upwards.
8. Place pump onto the hooks on the mounting plate from above.
9. Slide pump downwards onto the mounting plate until it engages with an audible click.
10.
To remove the pump from the mounting plate, push down on the fixing
bracket (Fig. 10, pos. 10).
11. Attach the connecting lines (hydraulic and electric):
Ä Chapter 6.3.1 ‘Hydraulic installation’ on page 43
Ä Chapter 6.3.4 ‘Electrical installation’ on page 51.
Assembly, installation, modification and upgrades
41 Rev. 2-05.2018

Ecolab EcoAdd Specifications

General

Brand	Ecolab
Model	EcoAdd
Category	Water Pump
Language	English