CAUTION!
– Setup, installation and mounting work are to be performed exclusively by
authorised, trained and approved experts in compliance with prevailing
general guidelines and local regulations.
–
Special measures and protective equipment for metering hazardous or
aggressive chemicals are not listed here.
– When using them, it is imperative that you observe the statutory regulations
and the pertinent product data sheet for the metering medium being used.
6.2 Assembly variants
The pump can be mounted both
upright (e.g. on a bracket or on the
metering container
, pos. 1), as well
as on a wall (suspended, pos. 2).
Fig. 8: Stand mounting (pos. 1) and wall mounting (pos. 2)
For further variable use, the operating part of the pump can be turned to produce variable
connection variants. The dimensions of the pump and of the mounting plate can be seen
in
Ä
Chapter 13.7 ‘Dimensions’ on page 190 :
CAUTION!
– The mounting plate must be properly secured to the relevant surface and
the pump must be locked securely into the mounting plate.
–
Fit the mounting plate only to suitable surfaces that are able to withstand
any vibrations that may arise.
– The stability of the pump must be ensured.
– The pump must not be subjected to additional (weight) forces.
– Additional components may not be set up or deposited there, and people
must not stand on or attach items to pumps which have already been
installed.
– The fastening elements are marked with an embossed number 1 and 2 and
the design ensures that they will only fit into the recess in the mounting
plate in one direction.
Assembly, installation, modification and upgrades
39 Rev. 2-05.2018
To Next Page
Loading...
Need help?
General
