Ecolab EcoAdd User Manual

10. The notification screen ‘Maintenance not completed!’
is displayed. The internal
meter for the maintenance work performed (
Ä Chapter 7.11 ‘Operating data’
on page 120)
is not counted upwards.
After confirming this notification screen, the operating screen (pos. 13) is displayed
and the pump is ready for operation.
11.
Do not confirm the maintenance work:Pressing the OK button .
12. The notification screen ‘Maintenance completed!’
is displayed. The internal meter for
the maintenance work performed (
Ä Chapter 7.11 ‘Operating data’ on page 120)
iscounted upwards. After confirming this notification screen, the operating screen
(pos. 13) is displayed and the pump is ready for operation.
10.1.2 Maintenance mode - WITH access code
Fig. 111: Maintenance mode - WITH access code
Put the pump into maintenance mode:
1.
On the operating screen, press the maintenance symbol ( , or ).
To access the maintenance mode, press and hold the displayed
maintenance signal for around 3 seconds.
2.
If the [access code] is activated , the [access code] is entered.
If the [access code] is enabled , please note the following:
Ä Chapter 7.6 ‘Main menu’ on page 66.
Service
163 Rev. 2-05.2018

Ecolab EcoAdd Specifications

General

Brand	Ecolab
Model	EcoAdd
Category	Water Pump
Language	English