FlexRadio Systems FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 115
Copyright 2018 FlexRadio Systems. All Rights Reserved.
30.2 CABLE MANAGEMENT
USB Cables are managed through the USB Cables window found in the Settings -> USB Cables menu:
Using the USB Cables window, cables can be selected, activated and deactivated, modified, logged
and removed. The fields in the window are:
• Name – The name given to the USB Cable. Newly installed cables get a default name. The
name can be changed with the Edit command.
• Serial Number – The serial number of the USB Cable, read from the FTDI chip embedded in
the cable.
• Type – The type of the USB Cable. This field is limited to one of the following:
o CAT
o BIT
o BCD
o LDPA
• Enabled – Enables or disables the USB Cable.
The Edit, Log and Remove buttons perform a function on a selected cable. Clicking Edit opens a
window that allows the user to edit the settings of the selected cable. Clicking Log opens a window
that enables logging for a cable. Logging allows the user to see and monitor all traffic going across
the cable. For BIT and BCD cables the log indicates the bits written to a cable as a hexadecimal
number. Clicking Remove removes the cable from SmartSDR management. Note that cables can be
removed only when they are unplugged.

FlexRadio Systems FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio Systems
Model	FLEX-6000 Signature Series
Category	Transceiver
Language	English