FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 140
Copyright 2018 FlexRadio Systems. All Rights Reserved.
The Waveform Application is now installed in both the Windows computer and the radio. Any
Waveform modules may be uninstalled by opening the window above and selecting the module for
removal, then pressing the “Uninstall” button.
To uninstall a Waveform, open the Waveform Manager, select the appropriate wave form and click
on the Uninstall button.
Δ – Resetting the radio data base will erase any Waveform modules installed inside the radio. The
original copy is still stored in the SmartSDR application in the Windows control computer and can
easily be re-installed into the radio by opening the File/Waveform/Installer-Window and repeating
the installation step above.
33.3 OPERATING A WAVEFORM MODULE
The Waveform Module extends the capability of the radio by adding additional modes. When
installed, an additional mode button may appear alongside the existing mode buttons, such as the
case of FreeDV/CODEC2 adding a mode button labeled FDV alongside USB, LSB, FM, etc. Some
Waveform applications will not require any further controls or displays other than the mode button.
If additional GUI capability is needed, it will generally appear in a separate window. So, general
operation of the radio in the new added mode should be like existing operation. Instructions on how
to operate any added user interface (GUI) will be included as part of the module specific
documentation included as part of the module distribution.
Δ – The Waveform module adds an extra signal processing load on the radio. It is possible that
running a radio at or close to maximum processing capability and then adding a Waveform module
load could degrade the overall performance of the radio. In this case, it may be necessary to reduce
the total number of open receiver Slices, until the performance is acceptable.
To Next Page
Loading...
Need help?
General
