FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 184
Copyright 2018 FlexRadio Systems. All Rights Reserved.
38 ERROR AND STATUS MESSAGES
Various error and status messages regarding the operational state you your radio may be displayed
to inform you of conditions that require attention. The following section describes these messages.
If any of these errors occur frequently, immediately contact FlexRadio Support by submitting a
HelpDesk support ticket for assistance.
38.1 THERMAL OVER TEMPERATURE
If the temperature of the FPGA exceeds 120C a fatal error message will be displayed, and radio will
become unresponsive, requiring a reboot of the radio to recover. An FPGA over temperature
condition can be due to high ambient operating temperatures or insufficient cooling by the FPGA
cooling fan.
38.2 REVERSE RF POWER DETECTED
When a large amount of RF power is detected coming into the receiver, the receiver will
automatically be disconnected, and the transmitter will be unkeyed. Review your radio setup.
38.3 IMPORT CONFIG FAILED
This message will appear if a profile configuration import has failed. If a configuration import fails
multiple times, it may mean that the .ssdr_cfg file is corrupted.
38.4 INTERLOCK IS PREVENTING TRANSMISSION
This message means that there is a certain interlock condition that is preventing transmission. Details
on this interlock condition can be found near the bottom left corner of SmartSDR.
38.5 TRANSMIT SLICE HAS NOT BEEN SELECTED
A transmit slice must be selected for the radio to transmit. To select a transmit slice, press the TX
button on the Slice flag.
38.6 MAX POWER SET TOO LOW FOR ATU
This message indicates the Max Power setting for the radio is set too low for proper ATU operation.
Refer to section 35.6 to increase this value.
To Next Page
Loading...
Need help?
General
