FujiFilm CX 3240 - Connectivity

Device App
63
Setting Menus on Touch Screen
6
 Sleep Timeout
Specify a time period to enter the Sleep mode after entering the Low Power mode.
 Auto Power Off
Select this to automatically turn the printer off after a specified time has elapsed from
the Sleep mode. Use the slider bar to specify a value for turning the printer off.

[Always Allowed]
Turns the printer off when the specified time has elapsed.

[Allowed ONLY When Conditions are Met]
Turns the printer off only when the following conditions are all met during the time
you specified.
- The USB device port is not used.
- The wired network port is not used.
Feature Installation
Allows you to activate optional features.
Connectivity
Note

The displayed features may vary depending on your settings.

You can scroll the feature list up and down.
Primary Network
Displays [Ethernet].
Ethernet
 IPv4
Enable IPv4
Select this to enable the IPv4 mode.
Mode
Select a mode.

[DHCP with Auto IP]
The address, subnet mask, and gateway address will automatically be set via
DHCP/AutoIP. If the printer fails to communicate with the DHCP server, the AutoIP
function is automatically enabled and an IP address (169.254.xxx.xxx) is assigned
to the printer. When communication between the printer and the DHCP server
recovers, the printer obtains an IP address, a subnet mask, and a gateway address
by the DHCP server.

[Static]
The address, subnet mask, and gateway address will manually be set.

[BOOTP]
The address, subnet mask, and gateway address will automatically be set via
BOOTP.
Note

This is displayed only when this option is configured on Printer Configuration Web Tool.