To Next Page

To Previous Page

PT ONLY OR PS ONLY CONTROL MODES

K0553 Revision D 98 [EN] English

Pt Only or Ps Only Control modes

This mode can be used as an alternative to test airspeed indicators (ASI) using just the ADTS Pt

or Ps port connected to the ASI. An altitude correction may need entering into the ADTS if there

is a height difference and environmental draughts can cause airspeed errors.

NOTE: Enter a positive correction factor when ADTS is below the aircraft reference. Enter a negative

correction factor when ADTS is above the aircraft reference

Figure 3-41: Example of Pt Only Control Mode

How to use the Pt Only control mode

1) From Dashboard>> Pitot Static.

2) On the ADTS Touch, select the Aircraft status icon.

3) On the Aircraft status screen, tap the “tick” icon to start the Go to ground procedure

for all channels. The ADTS takes all channels to ground pressure.

4) When the aircraft is at ground, tap the “cross” icon to return to the Pitot Static screen.

5) Tap Home icon to return to the Dashboard.

6) From Dashboard >> Settings.

7) Select ADTS settings.

8) From the ADTS settings >> CHANNEL MODE.

9) From the channel mode screen, select “Ps”.

10) Select Measure Only. The Ps label changes to Measure Only.

GE ADTS542F User Manual

Other manuals for GE ADTS542F