FAULT CODES AND ERROR MESSAGES
K0553 Revision D 139 [EN] English
Fault codes and error messages
In the event of a malfunction, the built-in, self-test and diagnostic system displays a message
and the status indicator flashes a code. The message heading Error indicates a fault or condition
that interrupts normal operation.
If the display shows an error message, the unit should be switched off and then on again. If the
display still shows an error message after switching on again. the unit should be returned to GE
or a GE authorised repair depot.
Front Panel Four LED Flash Code
In a situation arising where all four of the LEDs on the front panel are flashing together with a
factory code sequence (presented in red and green LED colours), an ADTS controller & boot
loader software download should be attempted in the first instance. Once the software down-
loads are complete the unit is to be power cycled. If all four of the LEDs, after the power cycle,
are again presenting the flashing sequence the unit should be returned to a GE service depart-
ment.
To Next Page
Loading...
Need help?
General
