PREPARATION
K0553 Revision D 32 [EN] English
Preparation
WARNING
OBSERVE SAFETY PRECAUTIONS STATED IN LOCAL ORDERS AND THE AIRCRAFT OR EQUIP-
MENT SERVICING PROCEDURES.
CAUTION
IT IS THE RESPONSIBILITY OF THE USER TO MAKE SURE THAT THE PNEUMATIC CONTROL
RANGE LIMITS ARE SET BELOW THE MAXIMUM OPERATING LIMITS OF THE EQUIPMENT UNDER
TEST.
Make sure the electrical and pneumatic connectors, electrical cables and pipes and positioning
of the ADTS comply with the instructions and requirements in Section Positioning the ADTS.
CAUTION
DO NOT USE SHARP OBJECTS ON THE TOUCH SCREEN. SHARP OBJECTS WILL PERMANENTLY
DAMAGE THE TOUCH SCREEN, IT CANNOT BE REPAIRED.
Carry out the following before use:
1) If necessary, carry out the maintenance tasks detailed in Section Maintenance Tasks.
2) Make sure the power at the wall connection point is switched OFF. Connect the ADTS to the
electrical power supply at the wall connection point.
MAKE SURE THAT THE SUPPLY INCLUDES A CONNECTION TO A PROTECTIVE EARTH.
NOTE: Make sure that the power supply switch can be accessed at all times.
3) Inspect the pneumatic hoses for damage, ingress of dirt and moisture. Make sure the
aircraft adapters are serviceable.
To Next Page
Loading...
Need help?
General
