RATE TIMER MODE
K0553 Revision D 48 [EN] English
2) On the Set Time panel, select the required “hours”, “minutes” and “seconds” (2).
3) Tap the “Tick” icon (3), the Set Time panel closes and the new time is displayed in the Rate
Timer panel.
4) Taping the “Cross” icon (4), cancels the action and closes the Set Time panel.
To set the “TEST” period:
1) On the “Rate Timer” panel, tap “TEST” (5) to highlight it, the “Set Time” panel opens.
2) On the Set Time panel, select the required “hours”, “minutes” and “seconds”.
3) Tap the “Tick” icon, the Set Time panel closes and the new time is displayed in the Rate
Timer panel.
4) Taping the “Cross” icon, cancels the action and closes the Set Time panel.
To start and stop the Rate Timer:
1) To start the timer, tap the “play” icon (6). The timer starts counting down, the elapsed time
(percentage) indicator turns blue and the word “Wait” is displayed underneath the
percentage indication.
2) When the timer reaches 100%, it starts to count down again and the word “Test” is
displayed underneath the percentage indication. When the timer reaches 100%, it stops,
the elapsed time indicator remains blue and the word “End” is displayed. At the end of the
timed testing period the measured average rates of change are displayed for each channel
with the capital letter "T" as a suffix.
To Next Page
Loading...
Need help?
General
