POSITIONING THE ADTS
K0553 Revision D 29 [EN] English
Positioning the ADTS
CAUTION
TO OPERATE, PLACE THE ADTS ON A HORIZONTAL SURFACE WITH THE FRONT PANEL UPPER-
MOST, THIS ALLOWS THE WATER IN THE WATER FILTER TO VENT. WATER CAN CONTAMINATE
THE ADTS MANIFOLD AND AFFECT ADTS PERFORMANCE.
NOTE: In control mode, the water drain, located on the left-hand side of the unit near the cooling
vent, produces a flow of air and some water. The amount of water depends on the humidity and
the operating time in control mode.
It is important that the position of the ADTS in relation to the aircraft altitude sensors is known.
An altitude correction must be made to allow for the difference in height between the ADTS refer-
ence level and the reference level of the aircraft's altitude sensors (refer to the Aircraft Mainte-
nance Manual for this information).
Enter the altitude correction value, see section Settings.
To Next Page
Loading...
Need help?
General
