Chapter 4. Data Sets & Reports
124 USM Go Operator’s Manual
4.7 Creating a Report
IMPORTANT: Before proceeding be sure an SD card is installed in the instrument (see “Using the SD Slot, USB Connector & I/O
Connector” on page 13).
A report, with contents specified by the user, can be generated and stored on the USM Go SD card. The following features of the active data
set file can either be omitted from or included in the report:
• Header (use the HDR IN REPORT function)
• Memo (use the MEMO IN REPORT function)
• A-Scan Image (use the IMAGE IN REPORT function)
• Instrument parameters (use the PARAM IN REPORT function)
After configuring the report as desired, proceed to the next page to store the report.
To Next Page
Loading...
Need help?
General
