GE Ultrasonic USM Go User Manual

Chapter 5. Data Recorder Files
130 USM Go Operator’s Manual
5.2 Configuring the Data Recorder File
After entering a name for the data recorder file, the following parameters must be specified:
• TOP - the coordinates of the first cell in the file, using a row number and an column letter (e.g. 1A).
• BOTTOM - the coordinates of the last cell in the file, using a row number and an column letter (e.g. 10B).
• ADV DIRECTION - specifies the direction (DOWN or RIGHT) in which the DR advances after each thickness reading is recorded.
Use the usual joystick methods to select each of the above functions and program the desired values.
5.3 Creating the Data Recorder File
1. After naming and configuring the DR file, use the joystick ( ) to select the function titled CREATE.
2. Press the center of the joystick ( ) to create and activate a DR file that uses your previous selections.
IMPORTANT: After the DR file is created, the TOP and BOTTOM parameters cannot be changed. In fact, these functions are replaced on the
menu with listings of the NUM OF COLS and NUM OF ROWS, respectively.

GE Ultrasonic USM Go Specifications

General

Brand	GE
Model	Ultrasonic USM Go
Category	Measuring Instruments
Language	English