Chapter 2. Instrument Setup
22 USM Go Operator’s Manual
2.3 Initial Setup
In this section, you’ll learn how to configure the USM Go display and operating features. Follow these procedures to turn the instrument
ON and make initial adjustments to the control settings. Because the instrument can be set to save the control settings when it is turned OFF
and restore them when it is turned back ON, you won’t have to repeat these adjustments unless a change is required.
Power the instrument ON and note that the ACQUIRE menu is automatically activated. Activate the SETUP menu by pressing in and
holding the center of the joystick ( ).
Note: The entire menu structure is shown in Figure 8 on page 20 and Figure 9 on page 21.
2.3.1 Language, Units of Measurement, Date, and Time
Use the procedures in this section to adjust the units of measurement, the date, the time, and the language that appears on the display screen
and the data output. The adjustments require access to the REGIONAL and STARTUP function groups. These are accessed from the
CONFIG1 submenu in the SETUP menu, as shown in Figure 10 on page 23.
To Next Page
Loading...
Need help?
General
