GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 10 - Care & Maintenance 10-11
10-6-5 Physical Inspection
10-6-6 Optional Diagnostic Checks
Optionally you can access the diagnostic software as described in Chapters 5 or 7.
View the error logs and run desired diagnostics.
Table 10-12 Physical Checks
Step Item Description
1
Labeling Verify that all system labeling is present and in readable condition.
2
Scratches & Dents Inspect the console for dents, scratches or cracks.
3
LCD Monitor Display
Inspect the LCD Monitor Display for scratches and raster burns.
Verify proper operation of Contrast and Brightness controls.
4
Control Panel and
Keyboard
Inspect the Control Panel and Keyboard. Note any damaged or missing items.
(Replace faulty components, as required).
Verify proper operation of Control Panel backlighting and TGC sliders.
5
DVD+R/RW Drive
Clean the drive head and media with the vendor-supplied cleaning kit.Advise the user to repeat
this often, to prevent future problems. DVDs/CDs must be stored away from dust and cigarette
smoke. Do not use alcohol or benzene to clean the drive
6
Wheels & Brakes
Check all wheels and casters for wear and verify operation of foot brake, to stop the unit from
moving, and release mechanism. Check all wheel locks and swivel locks for proper operation.
7
Cables & Connectors
Check all internal cable harnesses and connectors for wear and secure connector seating.
Pay special attention to probe strain or bend reliefs.
8
Power Cord
Check the power cord for cuts, loose hardware, tire marks, exposed insulation or other
deterioration, and verify continuity. Tighten the clamps that secure the power cord to the unit and
the outlet plug to the cord.
9
Shielding & Covers
Check to ensure that all EMI shielding, internal covers, air flow panels and screws are in place.
Missing covers and hardware could cause EMI/RFI problems during scanning.
10
Peripherals
Check and clean the peripherals according to the manufacturer’s directions.
To prevent EMI or system overheating, dress the peripheral cables inside the peripheral cover.
11
External I/O Check all connectors for damage and verify that the labeling is good.
12
Op Panel Lights Check proper operation of all control panel key illuminations (flash once during system start-up).
To Next Page
Loading...
Need help?
General
