HIKVISION PanoVu Series User Manual

Steps
1. Go to
Conguraon → System → Security → IP Address Filter .
2. Check Enable IP Address Filter.
3. Select the type of IP address
lter.
Forbidden IP addresses in the list cannot access the device.
Allowed Only IP addresses in the list can access the device.
4.
Edit the IP address
lter list.
Add Add a new IP address or IP address range to the list.
Modify Modify the selected IP address or IP address range in the list.
Delete Delete the selected IP address or IP address range in the list.
5. Click Save.
11.13.3 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identy authencaon,
which improves the security of remote access.
Steps
1. Go to Conguraon → Network → Advanced Sengs → HTTPS .
2. Check Enable.
3.
Oponal: Check HTTPS Browsing to access the device only via HTTPS protocol.
4. Select a server cercate.
Note
• Complete
cercate management before selecng server cercate. Refer to Cercate
Management for detailed informaon.
• If the funcon is abnormal, check if the selected cercate is abnormal in Cercate
Management.
5. Click Save.
11.13.4 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1. Go to Conguraon → Network → Advanced Conguraon → QoS .
Stched PanoVu Camera with PTZ User Manual
100

HIKVISION PanoVu Series Specifications

General

Brand	HIKVISION
Model	PanoVu Series
Category	Security Camera
Language	English