To Next Page

To Previous Page

10.4 SNMP

You can set the SNMP network management protocol to get the alarm event and excepon

messages in network transmission.

Before You Start

Before seng the SNMP, you should download the SNMP soware and manage to receive the

device

informaon via SNMP port.

Steps

1. Go to the sengs page: Conguraon → Network → Advanced Sengs → SNMP .

2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.

Note

The SNMP version you select should be the same as that of the SNMP soware.

And you also need to use the dierent version according to the security level required. SNMP v1

is not secure and SNMP v2 requires password for access. And SNMP v3 provides encrypon and

if you use the third version, HTTPS protocol must be enabled.

3. Congure the SNMP sengs.

4. Click Save.

10.5 Access to Device via Domain Name

You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can

be mapped to a domain name

resoluon server to realize the network access via domain name.

Before You Start

Registraon on the DDNS server is required before conguring the DDNS sengs of the device.

Steps

1. Refer to TCP/IP to set DNS parameters.

2. Go to the DDNS sengs page: Conguraon → Network → Basic Sengs → DDNS .

3. Check Enable DDNS and select DDNS type.

DynDNS

Dynamic DNS server is used for domain name

resoluon.

NO-IP

NO-IP server is used for domain name resoluon.

4. Input the domain name informaon, and click Save.

5. Check the device ports and complete port mapping. Refer to Port to check the device port , and

refer to Port Mapping for port mapping

sengs.

6. Access the device.

Stched PanoVu Camera with PTZ User Manual

HIKVISION PanoVu Series User Manual

Other manuals for HIKVISION PanoVu Series