To Next Page

To Previous Page

3.4 Trac Congeson

This funcon is used to detect congeson in predened areas. When congeson happens within

the armed schedule, alarms and linked acons are triggered.

3.4.1 Basic Conguraon

You can set the basic informaon, camera No. and informaon, listening server, and ANR.

Go to Conguraon → Trac Congeson → Basic Conguraon to complete the sengs.

Basic Informaon

Input the Device No.

Camera

Input the Camera No. and Camera Info.

Listening Server

If the device uploads alarms in listening mode via our company's SDK, you should set the IP

address and port for the listening server.

ANR

When the network is disconnected, data is temporarily saved on the memory card. When the

network

connecon is resumed, the device automacally uploads the saved data to the arming

host, in which case, the arming host IP address is required.

Note

A memory card should be installed in the device. Memory card sengs should be completed.

See Memory Card for instrucons.

3.4.2 Set Trac Congeson Detecon Rules

Before You Start

Trac Congeson is supported by the panoramic channel. You need to select Trac Congeson for

Camera 02 or Camera 03 on VCA Resource page

rst.

Steps

1. Enable the

funcon in Conguraon → Trac Congeson → Rule .

2. Set a detecon area.

Click , and click on the live image to dene the boundary of the detecon area. Le click

to nish drawing.

Click to clear selected areas.

Click

to clear all the areas.

3. Set detecon parameters for the detecon area.

Stched PanoVu Camera with PTZ User Manual

HIKVISION PanoVu Series User Manual

Other manuals for HIKVISION PanoVu Series