HIKVISION PanoVu Series User Manual

Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Before You Start
• Install client and CA
cercates before conguraon. Refer to Cercate Management for
detailed
informaon.
• Select cercates according to the requirement of the log server. If two-way authencaon is
required, select the CA
cercate and the client cercate. If one-way authencaon is
required, select the CA cercate only.
Steps
1. Check Enable Log Upload Server.
2.
Oponal: Check Enable Encrypted Transmission if you want the log data to be encrypted.
3. Input Log Server IP and Log Server Port.
4.
Oponal: Select client cercate.
5. Select CA cercate to the device.
6. Click Test to test the sengs.
7. Click Save.
11.13.7 Control Timeout
Sengs
If this funcon is enabled, you will be logged out when you make no operaon (not including
viewing live image) to the device via web browser within the set meout period.
Go to
Conguraon → System → Security → Advanced Security to complete sengs.
11.13.8 SSH
Secure Shell (SSH) is a cryptographic network protocol for operang network services over an
unsecured network.
The SSH funcon is disabled by default.
Cauon
Use the funcon with cauon. The security risk of device internal informaon leakage exists when
the funcon is enabled.
11.13.9 Cercate Management
It manages the server/client cercates and CA cercate of the device.
Stched PanoVu Camera with PTZ User Manual
102

HIKVISION PanoVu Series Specifications

General

Brand	HIKVISION
Model	PanoVu Series
Category	Security Camera
Language	English