Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Driving and Operating 193
In an emergency, if the engine must
be turned off while the vehicle is
moving:
1. Push the key in toward the
steering column and turn the
key to Accessory.
2. Apply the brakes using a firm
and steady pressure. Do not
pump the brakes repeatedly as
this may deplete power
assistance, requiring increased
brake pedal force.
3. Shift the shift lever to
N (Neutral). Do not move it to
P (Park) as the transmission
will be damaged.
After shifting to N (Neutral),
firmly apply the brakes and
steer the vehicle to a safe
location.
4. Come to a complete stop. Shift
to P (Park). Push the key in
toward the steering column,
then turn the key to Lock/Off.
5. Apply the parking brake firmly.
See Parking Brake 0 204.
Starting the Engine
1. Apply the park brake.
2. Turn the key to position 1 while
moving the steering wheel
slightly to release the lock.
Move the shift lever to P or N.
Do not accelerate.
3. Turn the ignition key to position
2 until
K extinguishes.
4. Turn the key to position 3 and
release when the engine is
running.
Retained Accessory
Power (RAP)
The power outlets may be used
after the engine is turned off.
Note
The power outlets will continue to
operate for up to 10 minutes or until
a door is opened.
See Power Outlets 0 72.
Starting the Diesel
Engine
Observe the following precautions to
ensure maximum turbocharger
service life.
.
After starting the engine, let it
idle for approximately 1 to
2 minutes (avoid acceleration or
driving the vehicle).
.
Do not stop the engine
immediately after high-load
driving (such as high-speed
driving or driving up steep
gradients). Let the engine idle
for approximately 1 to 2 minutes
to cool it down.
To Next Page
Loading...
Need help?
General
