Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
204 Driving and Operating
Operation
ABS operation is noticeable by
pulsing of the brake pedal and the
noise of the regulation process.
The initial self-check may also be
audible.
Keep the brake pedal fully pressed
throughout the braking process,
without pumping it. Pumping the
brake pedal can reduce brake
efficiency.
If the vehicle is travelling above
50 km/h and ABS braking occurs,
the centrally mounted rear high-level
brake lamp will flash.
{
Warning
When the ignition is turned on,
the
! warning light briefly
illuminates. The self-check of the
ABS may be audible.
(Continued)
Warning (Continue d)
If the ! warning light (ABS off)
on the instrument panel display
does not extinguish, or illuminates
when driving, a malfunction has
occurred.
Note: The vehicle's brake system
remains operational, but without
ABS assistance. Have a Holden
Dealer check the system as soon
as possible.
See Brake System Warning Light
0 78.
Parking Brake
Applying the parking brake:
1. Apply the parking brake firmly
without engaging the release
button and apply as firmly as
possible when on an uphill or
downhill gradient.
Releasing the parking brake:
1. Pull the lever slightly upwards.
2. Press the release button and
lower the lever all the
way down.
To reduce the operating forces of
the parking brake, press the foot
brake at the same time.
{
Warning
Never drive the vehicle with the
parking brake applied.
See Brake System Warning Light
0 78.
Brake Assist
If the brake pedal is pressed quickly
and forcefully, maximum brake force
is automatically applied (full
braking).
Maintain steady pressure on the
brake pedal for as long as full
braking is required. Maximum brake
force is automatically reduced when
the brake pedal is released.
To Next Page
Loading...
Need help?
General
