Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
194 Driving and Operating
.
After changing the engine oil
and oil filter, start the engine and
let it idle for about 1 to 2 minutes
(avoid acceleration or driving the
vehicle).
.
Operate the engine above idle
speed only after normal engine
oil pressure has been
established. Forcing the
turbocharger to operate before
the bearings are adequately
lubricated creates unnecessary
friction.
.
Use only the specified engine oil
and observe the inspection and
replacement intervals.
.
At low outside temperatures or
when the vehicle has not been
used for a long period, normal
engine oil pressure and flow is
affected.
Under these conditions, the
engine should be started and
allowed to idle for a few minutes
before operating at higher rpms.
Parking
1. Apply the parking brake firmly
without engaging the release
button.
2. Move the shift lever to
P (Park).
On an uphill gradient turn the
front wheels away from
the kerb.
On a downhill gradient turn the
front wheels towards the kerb.
3. Close all windows.
4. Turn the ignition off to lock the
steering wheel.
5. Remove the key.
6. Press
Q on the key to lock all
doors. See Keys 0 18.
{
Warning
To avoid the possibility of injury,
always apply the parking brake
firmly before exiting the vehicle.
(Continued)
Warning (Continue d)
Be careful where you park or
drive. As with any vehicle, do not
park or operate this vehicle in
areas where combustible
materials such as dry grass or
leaves can come in contact with
the hot exhaust system.
Never leave the engine running in
an area such as a closed garage
or underground car park.
To Next Page
Loading...
Need help?
General
