Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Instruments and Controls 77
When the engine starts, the
symbols will be displayed in the
lower part of the DIC. If a rear seat
belt is buckled, the corresponding
symbol will dim.
Once the vehicle is travelling over
10 km/h for approximately
10 seconds, the symbols will
extinguish. If a rear seat belt is
unbuckled whilst driving, a chime
will sound and the corresponding
symbol will flash in the DIC.
Airbag and Seat Belt
Tensioner Light
.
The
9 warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
If the
9 warning light does not
illuminate, does not extinguish
after few seconds or illuminates
while driving, there is a problem
with the airbag or belt tensioner
system.
{
Warning
Have any fault in the airbag or
belt tensioner system repaired
immediately by a Holden Dealer.
See Seat Belts 0 44 and Airbag
System 0 48.
Charging System Light
The " warning light illuminates for
a short time when the ignition is
turned on to show that the light is
working.
If
" illuminates while the engine is
running, there is a problem with the
charging system:
1. Stop the vehicle and switch off
the engine.
2. Contact a Holden Dealer.
Malfunction
Indicator Lamp
.
The
* warning light
illuminates when the ignition is
turned on to show that the light
is working.
.
If the
* warning light
illuminates or flashes while
driving, there is a problem with
the emission monitoring system.
Contact a Holden Dealer.
.
The
* warning light may also
illuminate to indicate there is a
malfunction in the Diesel Particle
Filter (DPF). Contact a Holden
Dealer.
.
To avoid serious damage to the
vehicle, reduce vehicle speed,
avoid hard acceleration, avoid
steep uphill gradients and if
towing a trailer, reduce the
amount of cargo as soon as
possible.
To Next Page
Loading...
Need help?
General
