Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Driving and Operating 229
Conversions and
Add-Ons
Add-On Electrical
Equipment
Fitting Driving Lamps
Do not fit any accessory over the
upper or lower air intakes at the
front of the vehicle, as this may
affect engine cooling.
The Holden Genuine Accessories
are an exception, however they
should be removed in high load and
high temperature conditions.
Caution
In high load and high temperature
applications (e.g. towing) no
objects should be fitted over the
upper or lower air intake at the
front of the vehicle, as this could
affect cooling. This includes
removing Holden Genuine
Accessories in this area, in these
conditions.
Fitting Roo/Nudge Bars
If a roo/nudge bar is to be fitted, it is
critical that the Holden approved
roo/nudge bar is used. Other types
must not be fitted.
The Holden roo/nudge bar is
available from a Holden Dealer and
has been tested for compatibility
with the vehicle's design, including
the Holden airbag system.
{
Warning
Fitting other types of roo/nudge
bars may affect crash
performance, airbag performance
and engine cooling.
Roo/nudge bars should not be fitted
to vehicles operating in urban areas,
as they increase the risk of injury to
a pedestrian in the event of a
collision.
Snorkel Intake
It is necessary to reverse the
snorkel intake:
.
When driving in snowy
conditions.
.
Where there are other heavy
contaminants such as excessive
dust or insect swarms.
.
To prevent snow or other
contaminants from entering the
snorkel and engine air intake.
1. Loosen the two screws.
2. Remove the snorkel intake.
3. Rotate the snorkel intake 180º
and refit, securing with the two
screws.
To Next Page
Loading...
Need help?
General
