Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Driving and Operating 207
.
See Ride Control System
Messages 0 88.
Descent Control
System (DCS)
.
DCS allows the vehicle to travel
on a steep downhill slope at
speeds between approximately
4 km/h and 30 km/h without
pressing the brake pedal.
.
When the system is activated,
while the vehicle is moving at
speeds between approximately
4 km/h and 30 km/h it will
maintain the desired descent
speed when the vehicle is on a
steep gradient.
.
The desired descent speed
within the active range can be
varied by using the accelerator
or brake pedals to set the speed.
.
Noise or vibration from the brake
system may be noticeable when
the system is in operation.
Caution
Use only when descending steep
gradients while driving off-road.
Do not use when driving on
normal road surfaces.
Unnecessary usage of the DCS,
such as while driving on normal
roads, may damage the brake
system and the ESC function.
Activation
While travelling at speeds below
50 km/h:
.
Press
5.
5 illuminates green on the
instrument panel.
During operation,
5 flashes.
Note
.
Pressing the accelerator or
brake pedals while DCS is
activated, will adjust the desired
descent speed.
If pressed, DCS operation will
stop until the accelerator or
brake pedals are released.
5 stops flashing.
.
If the DCS is activated and the
vehicle speed exceeds 30 km/h,
5 extinguishes and the system
remains in standby mode.
When the vehicle speed drops
below approximately 30 km/h,
5
illuminates and DCS is
activated.
.
When in standby mode and the
vehicle speed exceeds 50 km/h,
DCS deactivates.
To Next Page
Loading...
Need help?
General
