Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
268 Vehicle Care
26. With the wheel on the ground,
use the wheel wrench to
tighten the wheel nuts in a
crosswise sequence.
{
Warning
As soon as possible after
changing a wheel, have the wheel
nuts tightened with a torque
wrench to 140 Nm (Newton
metres). Wheel nuts must be
tightened evenly to the correct
torque, as wheel nuts which have
not been tightened properly could
(Continued)
Warning (Continue d)
eventually allow the wheel to
come off while the vehicle is
moving.
27. Stow the replaced wheel, by
reversing Steps 8 to 13.
28. Stow the tools in the storage
compartment. See Tools 0 256.
29. Have the flat tyre renewed or
repaired.
When reinstalling the repaired
wheel:
1. Install the centre cap.
2. Place the cap on the wheel and
tap it into place until it is flush
with the wheel.
Jump Starting
Read the following warnings and
procedure in full before attempting
to jump start the vehicle.
If you are still unsure about jump
starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek the
assistance of a suitably trained
service technician.
{
Warning
Do not push start or tow start the
vehicle. Therefore, if the battery is
flat, jump start, but do not push
start the vehicle.
Batteries produce explosive
gases, contain corrosive acids
and supply levels of electrical
current high enough to cause
burns. Therefore, adhere to the
following when working near a
battery:
(Continued)
To Next Page
Loading...
Need help?
General
