Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Vehicle Care 243
Diesel Fuel System
Bleeding
The system requires bleeding if the
vehicle has run out of fuel.
Note
A minimum of 5 litres of diesel fuel
must be in the tank for the bleeding
operation to work correctly.
1. Turn the ignition on for
15 seconds, and then off.
2. Repeat Step 1 three times.
3. Start the engine for a maximum
of 40 seconds.
4. Repeat Steps 1 to 3 after
5 seconds.
If the engine does not start,
contact a Holden Dealer.
Wiper Blade Replacement
Regularly check the condition of the
wiper blades.
.
Replace hard, brittle or cracked
blades or those that smear dirt
on the windscreen.
.
If the blades are not wiping
properly, clean both the blades
and the windscreen. See
Exterior Care 0 273.
Bulb Replacement
Contact a trained service technician
if unsure about the bulb
replacement process.
When replacing bulbs:
.
Turn the ignition off and remove
the key.
.
Turn off related switches.
.
Fit bulbs of the specified
wattage only.
.
Do not touch bulbs or reflectors
with bare hands.
.
Clean stained bulbs with
methylated spirits.
Bulbs to be Changed by a Holden
Dealer
.
Daytime running lamps (DRL).
.
Fog lamps.
.
Turn signal lamps in the exterior
mirrors.
.
Centre high mount brake lamp.
.
LED rear lamps.
.
Courtesy lamp.
To Next Page
Loading...
Need help?
General
