Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
256 Vehicle Care
Vehicle Tools
Tools
The jack and tools are located
behind a cover on the driver’s side
of the load compartment. See Tyre
Changing 0 263.
1. Lift lever to unlatch.
2. Remove the cover.
3. Unhook the strap.
4. Remove the jack.
5. Remove the tools.
Wheels and Tyres
Tyre and Rim Condition
.
To avoid tyre and rim damage
and possible tyre blow-out, do
not drive over sharp edges.
.
Drive over edges slowly and at
right angles, if possible.
.
When parking, ensure the tyres
are not pressed against the
edge of the kerb.
.
Check the tyres regularly for
damage, stones, punctures,
cuts, cracks, bulges, etc. Check
the rims for damage. Contact a
Holden Dealer, if in doubt.
Tyre Pressure
Keep the tyres at the recommended
pressures to avoid increased fuel
consumption, uneven and
premature tyre wear.
.
Tyre pressure should be
checked when cold as tyre
pressure will increase as the
tyres warm up.
.
Check the air pressure of tyres
(including the spare) weekly to
ensure occupant safety, as well
as reducing fuel consumption
and increasing the life of the
tyres.
.
Replace any valve dust caps or
extensions.
Tyre Placard
The correct pressures for tyres are
shown on the tyre placard in the
driver ’s door frame and in the tyre
pressure table. See Tyre Pressure
0 289.
To Next Page
Loading...
Need help?
General
