GENERAL
INFORMATION
STANDARD TORQUE VALUES
FASTENER TYPE
I
Nm (ktafm. lbf-ft)
11
FASTENER TYPE v(knf-m, lbf-ft)
4
5
mm hex bolt and nut
I
5.2 i6.5.3.81
i/
5
mm
screw 4.2 (0.4.3.2)
6 mm hex bolt and nut
-
10 mm hex bolt and nut
12 mm hex bolt and nut
ENGINE
&
FRAME TORQUE VALUES
a
Torque specifications listed below are for important fasteners.
a
Others should be tightened to standard torque values listed above.
FRAMEIBODY PANELSIEXHAUST SYSTtM
MAlNTENANCt
Timing hole cap
1
Crankshaft hole cap
ITEM
Left crankcase rear cover bolt
Valve adjusting screw lock nut
TORQUE
N-m (kgf-m, Ibf-ft)
13 (1.3, 9)
REMARKS
CT bolt
Q'TY
1
THREAD
DIA. (mm)
10
14
30
THREAD
DIA. (mm)
6
Engine oil filter cartridge
Engine oil drain bolt
TORQUE
1
1
N-m (kgf-m, Ibf-ft)
l6 (1.6, 12)
10 (1.0,7)
LUBRICATION SYSTEM
REMARKS
Apply engine oil to the
threads and flange surface
Apply engine oil to the
-
Apply engine oil to the
threads and flange surface
ITEM
THREAD
/
1
DIA. (mm)
-
REMARKS
Apply sealant
to
the
Apply engine oil to the
threads
CT bolt
ITEM
Oil pressure switch
Oil pressure switch terminal screw
Oil cooler bolt
Oil pump assembly bolt
FUEL SYSTEM
ECT sensor
ThW
IACV screw
Set plate torx screw
Throttle cable guide screw
,
Fuel injector mounting bolt
TORQUE
N-m (kqfm. Ibf-ftl
TORQUE
~.m (kgfm, ~bf-ft)
12 (1.2,9)
1.9 (0.2, 1.4)
64 (6.5,47)
13 (1.3,9)
Q'TY
1
1
1
3
REMARKS
COOLING SYSTEM
1
1
3
2
2
4
THREAD
DIA.
(mm)
PT 118
4
20
6
I
.
.
12
5
5
5
5
5
ITEM
Water pump cover bolt
Nm (kgf-m, Ibf-ft)
13 (1.3, 9)
REMARKS
CT
bolt
Q'TY
5
1
DIA. (mm)
6