Honda NT700V Deauville Service Manual

MAINTENANCE
Fill the reservnlr wtb DOT 4 hrake €rm a
. .
sealed container to the casting ledge.
Install the diaphragm, set plate and reservoir cap
and tighten the cap screws.
TORQUE: 1.5 N-m (0.2 kgf-m, 1.1 Ibf-ft)
REAR
it in an upright position.
Check the rear brake reservoir fluid level.
Remove the seat (page
3-5).
If the fluid level is near the "LOWER" level mark,
remove the reservoir cap, set plate and diaphragm.
Fill the reservoir with DOT
4 brake fluid from a
Install the diaphragm, set plate and reservoir cap
securely.
BRAKE PADS WEAR
FRONT BRAKE PADS
Replace the brake pads if either pad is worn to the
wear limit groove.
Always replace the For brake pad replacement, refer to page 17-14.
to assure even disc
pressure.
"LOWER" LEVEL MARK
BRAKE PADS
WEAR LIMIT GROOVES

Honda NT700V Deauville Specifications

General

Displacement	680 cc
Bore x Stroke	81 mm x 66 mm
Compression Ratio	10.0:1
Fuel System	PGM-FI electronic fuel injection
Starter	Electric
Transmission	5-speed
Final Drive	Shaft
Front Tire	120/70 ZR17
Engine Type	Liquid-cooled, 4-stroke, SOHC, 52° V-twin
Max Power	65 hp (48 kW) @ 8000 rpm
Ignition	Computer-controlled digital with electronic advance
Front Suspension	41 mm telescopic fork, 115 mm travel
Rear Suspension	Single shock, Pro-Link swingarm, 120 mm travel
Front Brakes	296 mm dual hydraulic disc
Rear Brakes	276 mm hydraulic disc
Rear Tire	150/70 ZR17
Seat Height	805 mm
Fuel Capacity	19.7 liters
Wheelbase	1, 475 mm (58.1 inches)