Use undo mac-authentication domain to restore the default.
Syntax
mac-authentication domain domain-name
undo mac-authentication domain
Default
No authentication domain is specified for MAC authentication users. The system default authentication
domain is used. For more information about the default authentication domain, see the domain default
enable command in "AAA commands."
Views
System view, Ethernet interface view
Predefined user roles
network-admin
Parameters
domain-name: Specifies the name of an ISP domain, a case-insensitive string of 1 to 24 characters.
Usage guidelines
The global authentication domain applies to all MAC authentication-enabled ports. A port-specific
authentication domain applies only to the port. You can specify different authentication domains on
different ports.
A port chooses an authentication domain for MAC authentication users in this order: the authentication
domain specified on the port, the global authentication domain specified in system view, the default
authentication domain.
Examples
# Specify domain domain1 as the global MAC authentication domain.
<Sysname> system-view
[Sysname] mac-authentication domain domain1
# Specify domain aabbcc as the MAC authentication domain on port Ten-GigabitEthernet 1/0/1.
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mac-authentication domain aabbcc
Related commands
• display mac-authentication
• domain default enable
mac-authentication max-user
Use mac-authentication max-user to set the maximum number of concurrent MAC authentication users
on a port.
Use undo mac-authentication max-user to restore the default.
111
To Next Page
Loading...
Need help?
General
