Views
IPsec transform set view
Predefined user roles
network-admin
Parameters
ah: Specifies the AH protocol.
ah-esp: Specifies using the ESP protocol first and then using the AH protocol.
ah: Specifies the AH protocol.
Usage guidelines
The two tunnel ends must use the same security protocol in the IPsec transform set.
Examples
# Specify the AH protocol for the IPsec transform set.
<Sysname> system-view
[Sysname] ipsec transform-set tran1
[Sysname-ipsec-transform-set-tran1] protocol ah
qos pre-classify
Use qos pre-classify to enable the QoS pre-classify feature.
Use undo qos pre-classify to restore the default.
Syntax
qos pre-classify
undo qos pre-classify
Default
The QoS pre-classify feature is disabled. That is, QoS uses the new IP header of IPsec packets to perform
traffic classification.
Views
IPsec policy view, IPsec policy template view
Predefined user roles
network-admin
Usage guidelines
The QoS pre-classify feature enables QoS to classify packets by using the IP header of the original IP
packets.
Examples
# Enable the QoS pre-classify feature.
<Sysname> system-view
[Sysname] ipsec policy policy1 100 manual
352
To Next Page
Loading...
Need help?
General
