not want the port to use such authorization attribute for users, you can use this command to ignore the
authorization information received from the server.
Examples
# Configure port Ten-GigabitEthernet 1/0/1 to ignore the authorization information from the
authentication server.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port-security authorization ignore
Related commands
display port-security
port-security enable
Use port-security enable to enable port security.
Use undo port-security enable to disable port security.
Syntax
port-security enable
undo port-security enable
Default
Port security is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
You must disable global 802.1X and MAC authentication before you enable port security on a port.
Enabling or disabling port security resets the following security settings to the default:
• 802.1X access control mode is MAC-based, and the port authorization state is auto.
• Port security mode is noRestrictions.
When online users are present on a port, disabling port security also logs off the online users.
Examples
# Enable port security.
<Sysname> system-view
[Sysname] port-security enable
Related commands
• display port-security
• dot1x
123
To Next Page
Loading...
Need help?
General
