sa idle-time
Use sa idle-time to set the IPsec SA idle timeout for an IPsec policy or IPsec policy template. If no traffic
matches an IPsec SA within the idle timeout interval, the IPsec SA is deleted.
Use undo sa idle-time to restore the default.
Syntax
sa idle-time seconds
undo sa idle-time
Default
An IPsec policy or IPsec policy template uses the global IPsec SA idle timeout.
Views
IPsec policy view, IPsec policy template view
Predefined user roles
network-admin
Parameters
seconds: Specifies the IPsec SA idle timeout, in the range of 60 to 86400 seconds.
Usage guidelines
This function applies only to IPsec SAs negotiated by IKE and takes effect when the ipsec sa idle-time
command has been configured.
The IPsec SA idle timeout configured in IPsec policy view or IPsec policy template view takes precedence
over the global IPsec SA timeout configured by the ipsec sa idle-time command.
Examples
# Set the IPsec SA idle timeout to 600 seconds for the IPsec policy.
<Sysname> system-view
[Sysname] ipsec policy map 100 isakmp
[Sysname-ipsec-policy-isakmp-map-100] sa idle-time 600
Related commands
• display ipsec sa
• ipsec sa idle-time
sa spi
Use sa spi to configure an SPI for IPsec SAs.
Use undo sa spi to remove the SPI.
Syntax
sa spi { inbound | outbound } { ah | esp } spi-number
360
To Next Page
Loading...
Need help?
General
