266 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
1774-Slot X Drive Array - Obsolete Data Found in Array Accelerator
Audible Beeps: None
Possible Cause: Drives were used on another controller and reconnected to the
original controller while data was in the original controller cache. Data found in
the array accelerator is older than data found on the drives and has been
automatically discarded.
Action: Check the file system to determine whether any data has been lost.
1775-Slot X Drive Array - ProLiant Storage System Not Responding
SCSI Port Y:
...Check storage system power switch and cables. Turn the system power off while checking
the ProLiant power and cable connections, then turn the system power back on to retry.
Audible Beeps: None
Possible Cause: Storage system problem detected. A SCSI enclosure seems to be
connected to the specified SCSI bus, but no drives or SCSI backplane processor
were detected on this bus.
27
Action:
1. Power down the server ("Powering down the server" on page
).
2. Check the external ProLiant power switch. External drives must all be
powered up before the main system is.
3. Be sure cables are connected properly and securely.
4. Update the firmware.
5. If the problem persists, replace the cable, backplane, or Smart Array
Controller.
1776-Slot X Drive Array - SCSI Bus Termination Error
...Internal and external drives cannot both be attached to the same SCSI port. SCSI port Y:
Check cables
To Next Page
Loading...
Need help?
General