5
5-45
Power windows
The Engine Start/Stop button must be in
the ON position to be able to raise or
lower the windows. Each door has a
power window switch to control the
door’s window. The driver has a Power
Window Lock button that can block the
operation of rear passenger windows. The
power windows operate for about 3
minutes after the Engine Start/Stop
button is in the ACC or OFF position. If the
front doors are opened, the battery power
is turned OFF and the Power Windows do
not operate.
Window opening and closing
2C_WindowAutoReverse
To open:
Press the window switch down to the first
detent position (5). Release the switch
when you want the window to stop.
To close:
Pull the window switch up to the first
detent position (5). Release the window
switch when you want the window to
stop.
if equipped
Auto up/down window
Pressing the power window switch
momentarily to the second detent
position (6) completely lowers or lifts the
window even when the switch is released.
To stop the window at the desired
position while the window is operating,
pull up or press down and release the
switch.
• Do not leave the vehicle running and
the key in your vehicle with
unsupervised children. Unattended
children could operate the window,
which could result in serious injury.
• Do not extend your head, arms or any
other body parts or objects outside the
window while driving to avoid serious
injury.
Resetting the power windows
If the power windows do not operate
normally, the automatic power window
system must be reset as follows:
1. Press the Engine Start/Stop button to
the ON position.
2. Close the window and continue pulling
up on the power window switch for at
least one second.
If the power windows do not operate
properly after resetting, contact an
authorized HYUNDAI dealer.
Make sure body parts or other objects are
out of the way before closing the
windows. The automatic reverse feature
does not operate while resetting the
power window system.
Hyundai_SX2_en_US.book Page 45
To Next Page
Loading...
Need help?
General
