Driver Assistance System
7-144
The function will pause in the following
conditions when:
• There is a pedestrian, animal or object
in the direction the vehicle is moving
• The door or liftgate is open
• The Forward ( ) or Backward ( )
button is not continuously pressed
• Simultaneously pressing multiple
buttons on a smart key
• The smart key is not operated within 13
ft. (4 m) from the vehicle
• Button of another smart key is pressed
in addition to the operating smart key
• Blind-Spot Collision Warning or Rear
Cross-Traffic Collision-Avoidance
Assist operates while the vehicle is
being controlled in the reverse
direction.
• The vehicle moves 22 ft. (7 m) while the
smart key is pressed with Remote
Operation function (maximum travel
distance per button press)
The function will cancel in the following
conditions when:
When Remote Operation function is
canceled, the vehicle will automatically
stop, shift the gear to P (Park) and engage
EPB (Electronic Parking Brake).
• The steering wheel is turned
• The gear is shifted while the vehicle is
moving
• Operating EPB while the vehicle is
moving
• The engine hood is open
• The brake pedal or accelerator pedal is
depressed when all the doors are
closed
• The smart key is outside the vehicle
when the brake pedal is depressed
while the driver's door is open
• Rapid acceleration occurs
• Vehicle skid occurs
• The wheel is stuck by an obstacle and
cannot move
• About 3 minutes and 50 seconds has
passed after Remote Operation
function has started to operate
• The slope of the road exceeds the
operational range
• The function is paused for more than 1
minute
• The total travel distance of the vehicle
has exceeded 45 ft. (14 m) after Remote
Operation function operation
• The steering wheel, gearshift, braking,
and drive controls are not working
properly
• There is a problem with the smart key or
the smart key battery is low
• ABS, TCS or ESC system operates due
to slippery road conditions
• The alarm of the Theft Alarm System
sounds
Remote Smart Parking Assist
malfunction and limitations
Remote Smart Parking Assist
malfunction
Remote Smart Parking Assist check
2C_CheckRSPAInfo
When Remote Smart Parking Assist is not
working properly, the “Check Parking
Assist” warning message will appear on
the infotainment system. If the message
appears, stop using Remote Smart
Parking Assist, and have the vehicle
inspected by an authorized HYUNDAI
dealer.
Hyundai_SX2_en_US.book Page 144
To Next Page
Loading...
Need help?
General
