What to do if Jandy Controller AquaLink Touch frozen at "waiting for connection" screen?
If your Jandy AquaLink Touch controller is frozen at the "waiting for connection" screen, it indicates that the power center microprocessor might be locked. To resolve this, turn off the power to the system, wait for one minute, and then turn the power back on.
Why Jandy Controller AquaLink Touch displays "Waiting for connection" and override switches don't operate?
If the AquaLink Touch controller backlight is on, displaying "Waiting for connection...", but the power center override switches aren't working, the issue could stem from a damaged or improperly installed CPU board, the wrong CPU board being installed, or a damaged power center PCB. To address this: 1. Check the alignment of the CPU board. 2. Ensure the CPU board is revision Q or later. 3. If the CPU board is correctly installed, consider replacing the power center PCB.
General| Brand | Jandy |
|---|---|
| Model | AquaLink Touch |
| Category | Controller |
| Language | English |
To Next Page
