EasyManuals Logo
Home>Jandy>Controller>AquaLink Touch

Jandy AquaLink Touch User Manual

Jandy AquaLink Touch
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Page 44
AquaLink
®
Touch™ Owner's Manual
Section 11. Heat Pump Setup
11.1 Solar Priority/Heat Pump Priority
The SOLAR PRIORITY/HEAT PUMP menu allows the
system to use SOLAR HEAT/HEAT PUMP primarily.
If Solar Heat is no longer available, the system will
automatically switch to the alternate heat source.
MENU > SYSTEM SETUP > SOLAR PRIORITY
From the SYSTEM SETUP screen, touch the SOLAR
PRIORITY button to enable the solar priority feature.
H
o
m
e
Menu OneTouch Help Back Status
Photos
Power
System Setup
Dusk
Setup
Heat
Pump
PLockOut
Enabled
Air Temp
Enabled
HP Priority
N/A
DST
Enabled
Temp
Calibrate
Slr Priority
Disabled
All Off
Time
Product
Info
Degrees
Assign
JVAs
Thu January 1, 2009 3:03 PM
When solar and heater are enabled the solar will heat
the water until either the thermostat setting has been
reached or solar heat is no longer available. If the solar
panel is not hot enough, solar heat will shut off and the
other heat source (usually gas heater) will take over to
bring the water up to the thermostat setting. This menu
is used to ENABLE or DISABLE the solar priority.
NOTE Depending on the position of DIP switch S2-1
and the presence of a solar or heat pump
sensor, SOLAR PRIORITY or HEAT PUMP
PRIORITY may be displayed on the SYSTEM
SETUP menu. It is not possible to have both
SOLAR PRIORITY and HEAT PUMP PRIORITY
displayed on SYSTEM SETUP MENU at the
same time. It is one or the other.
11.2 Heat Pump (Heat Mode)
NOTE This equipment may not be part of your system.
Please check with your installer.
The HEAT MODE selection controls the heat pump
operation.
10.23 Cancel Delay
NOTE This feature is for use by service personnel
only.
MENU > SYSTEM SETUP > CANCEL DELAY
From the SYSTEM SETUP screen, touch the CANCEL
DELAY button.
Hom
e
Menu OneTouch Help Back Status
Photos
Power
System Setup
In-Floor
Disable
Clear
Memory
Cancel
Delay
Chemlink
Thu January 1, 2009 3:03 PM
NOTE CANCEL DELAY should only be used by
authorized service personnel. It should not be
used during normal system operation.

Table of Contents

Other manuals for Jandy AquaLink Touch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jandy AquaLink Touch and is the answer not in the manual?

Jandy AquaLink Touch Specifications

General IconGeneral
BrandJandy
ModelAquaLink Touch
CategoryController
LanguageEnglish

Related product manuals