Jandy AquaLink Touch User Manual

Page 26
AquaLink
®
Touch™ Owner's Manual
8.4.1 To Enable Slideshow
The SLIDESHOW button is used to enable or disable
the slideshow. When ENABLED, the slideshow will be
displayed continuously as set by the SLEEP MODE or
by the NO ACTIVITY mode.
▪ DEFAULT - Disable
HOME > PHOTOS > SETUP > SLIDESHOW ENABLED/
DISABLED
From the CHOOSE IMAGE screen, touch the SETUP
button to display the SLIDESHOW SETUP screen.
Touch the SLIDESHOW to enable the slideshow.
Ho
m
e
Slideshow
Enabled
No Activity
30 Sec
Sleep Mode
Enabled
Sleep Time
10:00 PM
Image Time
30 Sec
Slideshow Setup
Back
/
Fwd
S
lideshow
S
etu
p
D
e
l
ete
S
aveThumbs
/
Full
Thu January 1, 2009 3:03 PM
8.4.2 Image Time
The IMAGE TIME sets the duration time to display
each photo when the slideshow is running. This interval
may be set from five (5) seconds up to three (3)
minutes.
HOME > PHOTOS > SETUP > IMAGE TIME
From the SLIDESHOW SETUP screen, toggle the
IMAGE TIME button; the set time will switch from
five (5) seconds to 10 seconds, 30 seconds, one (1)
minute, and three (3) minutes. Select your choice and
the slideshow will show each picture for the length of
the designated time.
Thu January 1, 2009 3:03 PM
H
om
e
Slideshow
Enabled
No Activity
30 Sec
Sleep Mode
Enabled
Sleep Time
10:00 PM
Image Time
30 Sec
Slideshow Setup
Back
/
Fwd
Sl
i
d
es
h
o
w
S
etup De
l
ete
S
ave
T
humbs
/
Ful
l
8.4.3 Sleep Mode and Sleep Time
When enabled, the SLEEP MODE will turn off the
screen as set in SLEEP TIME.
PHOTOS > SETUP > SLEEP MODE
From the SLIDESHOW SETUP screen, toggle the
SLEEP MODE to enable or disable this feature.
Thu January 1, 2009 3:03 PM
Ho
m
e
Slideshow
Enabled
No Activity
30 Sec
Sleep Mode
Enabled
Sleep Time
10:00 PM
Image Time
30 Sec
Slideshow Setup
Back
/
Fwd
S
lideshow Setup D
e
l
ete
S
aveThumbs
/
Full
The SLEEP TIME sets the time to turn off the screen
when the SLEEP MODE is enabled.
PHOTOS > SETUP > SET TIME
From the SLIDESHOW SETUP screen, touch the
SLEEP TIME to display SLIDESHOW OFF TIME
screen.
Touch the CLEAR button to erase any existing time.
Use the numeric keyboard to set a new time. Toggle the
AM/PM button and select your choice. Touch ENTER
when finished.
8.4.4 No Activity
The NO ACTIVITY feature will turn off the screen
when no activity is detected, after the time set by this
control has elapsed.
The NO ACTIVITY time-out can be set 30 seconds, one
(1) minute, three (3) minutes, five (5) minutes, or OFF.
The OFF option will keep the screen ON indefinitely.
If the SLIDESHOW is enabled and the SLEEP MODE
is disabled, the slideshow will run until the screen is
touched again.
PHOTOS > SETUP > NO ACTIVITY
From the SLIDESHOW SETUP screen, toggle the NO
ACTIVITY button and select your choice.

Jandy AquaLink Touch Specifications

General

Brand	Jandy
Model	AquaLink Touch
Category	Controller
Language	English