JR XP810-3 User Manual

www.modelflight.com.au – World’s best source of JR products
4
.
1
1 Butte
r
fl
y
Mixin
g
(
Crow
)
(
Function Mode
)
, cont.
Indicates the channel
selected
SW Position
Channel Display
Mixing
V
alue
S
p
oiler Offset Postion
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Dual Fla
p
Trim
UP
DN SELECT CH CH CLEAR
Press the Clear key to
function
To Aileron to Rudde
r
Mixin
g
function
Select Function Changes:
⌫ Spoiler-Elevator mixing
↓
Spoiler-Aileron mixing
↓
Spoiler-Flap mixing
↓
S
p
oile
r
-Offset mixin
g
Mixing
V
alue
(increase or
decrease) for
a
pp
licable value
reset the Mixing
V
alu
e
to factory preset (0) o
r
sets the offset
p
osition
4
.
1
2 Dual Fla
p
T
rim
(
Function Mode
)
The purpose of the Dual Flap T rim is to allow the trimming of the
flap and aileron channels. Three seperate trim POT s are
accessible in the Dual Flap T rim Function. POT 5, located on the
top right of the transmitter , adjusts both aileron control sur faces
up/down in unison. POT 6, located on the right face of the
transmitter , acts as the flap trim of the Dual Flap T rim Function,
moving both flaps up/down simultaneously . POT 7, located on
the top left of the transmitter , trims the flaps in opposite directions
(as ailerons) Note: The Dual Flap Trim Function must be active.
A
lso, the aileron ratchet trim has no effect on the flaps.
In Function Mode, use the UP and DN keys to select Dual Flap
T rim Mixing and access by pressing the UP and DN keys
simultaneously .
Trim Display
Pot 5: Flaperon Flap Trim
Pot 6: Dual Flap-Flap Trim
Pot 7: Aileron Trim of Dual Fla
p
Setting Operation
⌫ Channel ⌫ INH
Each trim's operational
direction
GLID 122

JR XP810-3 Specifications

General

Brand	JR
Model	XP810-3
Category	Remote Control
Language	English